6 7
Battery Installation / Charging
Alkaline Battery Installation: Remove the BULLSEYE from its carrying case.
Hold the unit so the accessory connector is pointing upwards. Remove the dust
cap from the accessory connector. Loosen the two thumb screws and remove the
battery access cover. Install four “C” cell alkaline batteries as shown on the label
diagram inside the battery compartment noting the (+) and (-) terminals.
Replace the battery access cover. Firmly tighten the two thumbscrews. Replace
the accessory connector dust cap.
Nickel Metal Hydride (Ni-MH) Batteries: Rechargeable batteries require an
initial and subsequent charging time of approximately 3 hours. It may require
2 or 3 charging cycles to obtain maximum battery life. To charge, remove the
dust cap from the accessory connector. Insert the cannon adapter into the
accessory connector and tighten. Insert the charger into the cannon adapter.
Plug the charger into a 110-volt outlet. (European and Australian chargers allow
plugging into appropriate outlets.)
Battery installation diagram /
Serial number label
Cannon Adapter
Charger
The batteries may also be charged with a 12-volt auto cigarette lighter adapter.
The charge status indicator located on the back of the housing will remain solid
when the unit is charging. The indicator will blink when fully charged. When
charged, unplug the charger from the outlet and remove the cannon adapter
from the accessory connector.
Battery Installation / Charging
Built-in overcharging protection prevents damage if the unit is left on charge
after being fully charged. There is also charge protection for attempting to
charge alkaline batteries.
CAUTION:
Do not attempt to charge alkaline or other
disposable batteries.
NOTE: Do not charge Ni-MH batteries when ambient temperature
exceeds 113° F (45° C).
The rechargeable battery electronics include a charge error indicator. A
solid light on the right LED indicates an error with either the internal battery
connection, the charging temperature, or possible dead battery cell. Contact
your dealer service department if this light is displayed.
Rechargeable Battery Replacement - Remove the battery access cover.
A battery contact is located in the battery housing as illustrated. For proper
operation, a negative end of one rechargeable battery must have
the protective cover removed or "skinned" and positioned to
touch the contact in the housing as illustrated. Follow
the label diagram for the other batteries. Replace with
factory approved Ni-MH batteries only. Once installed,
replace the battery access cover, firmly tighten the two
screws and replace the dust cap. Charge as instructed
on page 6. Refer to your local requirements for the
proper disposal of rechargeable batteries.
Battery Contact
Rechargeable Battery
Cover Removed
Charge Status Indicator
Solid - Charging
Blinking - Charging Complete
Charge Error
Indicator
(Located on lower rear of polycarbonate housing)
(83 strony)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentarze do niniejszej Instrukcji