Apache Technologies Bullseye 3 Instrukcja Operatora Pobierz pdf (Strona 8)

1110

BULLSEYE 3™

Installation

Position the blade or bucket to the desired elevation (benchmark). If

using on and excavator or backhoe, the dipperstick should be vertical

and the bucket “curled” or extended to a position that can be easily

duplicated each time a reading is taken. To check that the plane of

laser light is intersecting the pipe where the receiver will be mounted,

move the BULLSEYE 3 up and down along the length of the mounting

pipe. Ideally you should be able to move the BULLSEYE 3 far enough

in either direction to utilize the entire reception range - receiving all the

grade displays and the lost beam indicators. If the full reception range

is not being used, raise or lower the rotating laser until the full

reception range is utilized.

Turn both the top and bottom knobs counterclockwise until the

mounting clamps in back open enough to fit around the mounting pipe

and place the BULLSEYE 3 on the pipe. Move the receiver up or down

until the “On-Grade” symbol is displayed by the LED’s. Tighten both

clamps firmly by hand. NOTE: Do not mount on painted poles if

possible. Paint may accumulate on the clamps and deteriorate the

clamps gripping capacity.

When mounted to a bulldozer, motorgrader, scraper or other grading

machine, the operator can keep the blade at the proper elevation by

manually controlling the blade so that the BULLSEYE 3 stays within

the “on-grade” zone. The LED display indicates in which direction the

blade needs to be moved to return to “on-grade”.

When mounted to a excavator or backhoe, the BULLSEYE 3 is a

grade checker and allows the depth of cut to be monitored from the

cab of the machine by the operator. This is done by putting the dipper

stick in the vertical position and the bucket in the setup position and

touching the bottom of the ditch.

To remove the BULLSEYE 3 from the machine, loosen the two

clamps. Store and transport the receiver in its carrying case.

Magnetic Mount Installation - Determine

where the mount will be located on the machine

so that when the BULLSEYE 3 is attached, it will

intersect the laser beam. Ensure the area of the

machine is clean and free of oil and grease. Angle

the mount so the top edge of the top magnet will

be positioned first. Holding the mount by the pipe

tube with both hands, place the top edge of the

magnet on the machine. Slowly move the bottom

magnet towards the machine so the mount

remains plumb. Attach and set-up the

BULLSEYE 3 in the normal manner as described

on the previous page.

To remove the magnetic mount, first remove the receiver from the

mounting pole. Use a scrap piece of wood or other long object as a

pry bar if necessary. Insert the pry bar in between the magnetic mount

pole and the machine. Pry the mount sideways to loosen the

magnetic hold. Once the magnetic hold is loosened, the mount can

be easily taken off the machine by hand.

When using the magnetic mount with the BULLSEYE 3 and plumb

sensor, mount the plumb sensor on the bottom extension of the pole.

This will ensure the BULLSEYE 3 can utilize the full range of the

magnetic mount pole.

Installation

1 2 3 4 5 6 7 8 9 10 11 12

Komentarze do niniejszej Instrukcji

Brak uwag

Apache Technologies Bullseye 3 Instrukcja Operatora Strona 8

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Odbiornik Apache Technologies Bullseye 3